Grohe kitchen faucet is available in different styles and finishes and is sold in home improvement and hardware upgrades around the world. You can install a grohe faucet in your kitchen sink using basic techniques and tools. If you do not have a faucet install before. The installation process will take more than one experienced installer, but the installation does not involve any special technique. If you find that any of the connections on your key start leaking after you have completed the installation, you must tighten the connections with the screwdriver or adjustable wrench.
You can disconnect the hot and cold water under the sink. Find the shut off valve for these supply lines and turn right to cut the water to the existing fitting. Test the faucet to make sure the source is off. If there are no shut off valves below your sink. And then turn off the main supply of water entering your home. Place a container or bucket under the Grohe kitchen faucet to collect water that may traps inside. Use a sink faucet to disconnect the supply lines between the existing faucet and the shut off valves. Turn the nuts to the left. Loosen and disconnect the lines from the key.
Open the old faucet and slide your Grohe kitchen faucet into the hole in the top of its stack. If the supply lines are join, feed them through the hole first so that they fall under the sink. Under the sink, screw the new faucet into place using the screws provided by grohe. Connect the water supply lines to your new faucet. Pay attention to where the hot and cold power lines are place. So you will end up with each of these lines on the desired side (cold right, for example). Use an adjustable wrench to tighten the compression nuts at the end of each power line to connect to the faucet.
Twist the aerator from the end of your wrench by hand. If it is too much, use an adjustable wrench to loosen it. Turn on the water supply under the sink and turn on the Grohe kitchen faucet so that the water will be through it. Let the water run for two minutes to remove any residue, then turn off the tap. Twist the aerator back to the end of the wrench to complete the project.